? ? ? ?

How to use the crimping tool of the terminal crimping machine?

For terminal crimping machines, first check whether the specifications of the crimping tools and wires can be matched. The crimping tools are not only used for pressing the wire, but also have three functions of trimming, pressing and stripping. Crimping tools generally have two stripping ports and three indenters, and at the end there is a trimming head. The indenter has 4P, 6P and 8P points, of which 8P is used for the crimping cable, and the pressing telephone line is to use 6P, which is the pressure telephone handset line.

There are two kinds of stripping ports: flat mouth and semi-round mouth. The semi-round port is used to strip the wire. Note that the stripping length should be about 13 cm away from the fracture. The flat mouth is used for stripping the telephone line. Note that the stripping length should be 8 cm from the fracture. The final cut is of course used to cut telephone lines and network cables.

The first edge of the crimping pliers is used for stripping. When the crimping tools are closed, they will have a gap of about 1.5 mm. The second one is no gap, it is used to cut the telephone line and network cable. The "convex" type in the middle of the crimping tool is used to press the wire, and it is inserted into a crystal head. The 8 saw teeth will just be aligned with the copper piece, but do not press hard, it will crush the crystal head.

Use the crimping tool to press the wire. Note that each wire must be placed on the front of the crystal head. The mesh skin should also enter the inside of the crystal head by 2 to 3 cm to increase the contact surface to prevent the wire from falling off. Eight of the wires do not need to be peeled, and only the copper piece in the crystal head needs to be pressed into the wire to be in contact with the copper wire. [terminal crimping machine]